Flanged Metal Shielded Deep Groove Ball Bearings : Manufactured to the same principal sizes as standard bearings but fitted with metal shields, these bearings have an additional flange to allow fitting into housings flush against the shoulder of the flange. They are often used on steel tracks as guides and supports. The shields serve to offer protection to prevent ingress of debris and dust whilst retaining the grease within the bearing.
Benefits: Cost effective replacement bearing, Flanged design, Metal shielded
Flanged Radial Bearings like these are also used within machines like 3D Printers that have timing belts, and allow the belt to move and rotate while the edge holds the belt in place and keeps it from sliding off. Typically, two of these bearings will be used together to keep belts centred, but double-flanged bearings can also be used instead.
Bearing Type | Ball |
For Load Direction | Radial |
Construction | Single Row |
Seal Type | Shielded |
Part Number | F686ZZ |
For Shaft Diameter | 6mm |
Bore Dia (d) | 6mm |
Bore Dia Tolerance | -0.008mm to 0 |
For Housing ID | 13mm |
Outer Dia (D) | 13mm |
Outer Dia Tolerance | -0.008mm to 0 |
Width (B) | 5mm |
Width Tolerance | -0.12mm to 0 |
Flange Outer Dia. | 15mm |
Flange Thickness | 1.1mm |
Ring Material | 52100 Chrome steel |
Ball Material | 52100 Chrome steel |
Cage Material | 300 Series Stainless Steel |
Shield Material | 300 Series Stainless Steel |
Dynamic Load Rating (Cr) (Newtons) | 920 |
Статическая грузоподъемность (Cor) (Ньютоны) | 354 |
Максимальная скорость (смазка) (X1000 об/мин) | 40 |
Максимальная скорость (масло) (X1000 об/мин) | 43 |
Смазка | Необходимый |
Тип крепления вала | Нажмите Fit |
Диапазон температур | от -30° до 110°С |
Рейтинг ЭКАБ | АВЕС-3 |
Радиальный зазор Торговый номер | С0 |
Радиальный зазор | от 0,002 мм до 0,013 мм |
RoHS | Соответствует |
Шар Кол-во | 8 |
Диаметр шара | 2.0000мм |
Вес (граммы) | 3.06 |
1 Применимо только для открытых, одинарных Z, ZZ, одинарных RU и 2RU типов при вращении внутреннего кольца. Максимум. скорости для типов контактных резиновых уплотнений будут составлять около 50-60 % от вышеуказанных значений.